Chipping capacity: 15″
Height: 8’10”
Width: 6’11”
Length: 16’5″
Weight (approximate): 7,200 lbs.
Suspension: 7,000 lb. Torflex
Infeed opening: 55 ½” wide x 34″ high
Throat opening: 20 ½” wide x 16″ high
Drum: 23 ¾” wide x 21 3/8″ diameter
Engine: CAT, Cummins, GM, John Deere or Perkins
Horsepower: 97–142 HP
Fuel capacity (tank): 32 gallons
Hydraulic oil capacity: 13 gallons
Frame: 8.2 lb., 6″ channel
Tires: (2) 215/75Rx17 ½”
Hitch: 2 ½” Pintle Ring
Equipment Highlights
23 ¾” wide x 21 3/8″ diameter staggered-knife pocket drum with two dual-edged chipper knives and dual-sided, chambered air impeller systems
Single (top) horizontal feed wheel with TorqMax top feed wheel compression system, hydraulic lift assist, spring assisted down pressure and manually applied hydraulic down pressure at the valve handle
Reversing automatic feed system
Enclosed engine with gauge panel, radiator fines screen and slide rails for belt adjustment
Fuel tank sight gauge, drain plug and shutoff valve
Hydraulic tank shut-off valve, drain plug and clean-out cover
Morthane Paint System: A chemically cured, electrostatically applied urethane coating with high-gloss finish, built-in UV protection, chip and chemical resistance and corrosion protection.
Options:
- ChipSafe® Operator Safety Shield
- Winch package: heavy-duty, 5,000 lb. pull capacity with rope and 10′ chafe guard
- Custom paint and logo packages
- Bottom Bump Bar
- Hydraulic Swivel Discharge
- Cone Holder
- Spare Tire/Mount
- Folding Infeed Tray
- Bottom Feedwheel
- Flow Control
- Axle, Fender and Battery Box Options Available